Fitrite Industrial Co.,Ltd

High quality product, professional service, being the core supplier in laser industry!

Home > News > Content
Installation Of Electrical Cabinet Lock Tips
- Oct 24, 2017 -

When installing the electrical cabinet lock, it is best to find an experienced lock master to help you install, and according to the instructions on the model openings, lock, keyhole and other pre-installation need to prepare the work, to see the hole is accurate, To strictly follow the product installation steps. After installing the electrical cabinet lock and found that the lock is not working or can not open, should immediately consult the installation of the master, and find the reasons, the door is usually dry when the paint is not completely dry, install a new lock. This is because it prevents paint from sticking to the lock. Some paint is corrosive and will reduce the life of the lock!

In the choice of electrical cabinet lock, to choose a quality assurance lock, it is best to have the manufacturer and the production address of the lock, pay attention to purchase, to choose the same door and open the door, and pay attention to the door of the border distance. The ball lock and handle lock can be mounted on the door. After installation of locks to pay attention to maintenance. First, do not go to the lock cylinder drip oil, if the key is open when the invalid, you can put a little pencil in the eyes of the pencil core chip, do not use a damp cloth to wipe the lock body, to avoid rust, do not force too hard, do not force Impact the door, to avoid reducing the life of electrical cabinet locks.

Replacement steps of the cabinet door lock cylinder

Do you still worry about how to replace the door lock and do not know how to replace it? Do not worry, today Zhongzheng Xiaobian teach you how to replace the cabinet lock lock cylinder.

1, with flat mouth chisel, open the inner panel of the rivets.

2, so that after the linkage of the three connecting shafts were opened, be careful not to lose parts.

3, remove the screws under the fixed linkage mechanism, and then remove the linkage mechanism.

4, remove the outer panel.

5, remove the buckle spring, and then remove the two screws, remove the control lever, remove the lock cylinder.

6, follow the reverse steps in step 5 back to the lock cylinder.

7, if the outer core of the core is too small, can not make the key through, you need to reamer.

8, back to the linkage mechanism.

9, commissioning, the appropriate release of the linkage mechanism of the fixed screws, non-stop door, and then adjust the lever and other components of the degree of protrusion.

10, the final cabinet door panel with rivet gun mounted.